Southwestern States Commercial Service 1.877.828.2473   

Pigeon Bird Control Commercial Cooling & HVAC Units

Pigeons just love to nest under large HVAC units on commercial building as well as swamp coolers and smaller air conditioners that are mounted up on 4x4 wooden blocks.

FACT: Pigeons on a roof top can reduce the life of the roof 20% or more

A/c units and other coolers allow just enough room for the pigeons to nest under the protection of the units and get out of the sun.

Leave the swamp pads and cover off of just 1 old swamp cooler on your warehouse and you have provided enough nesting space for 1/2 a dozen mated pairs of pigeons or more, which means that you will have dozens of pigeons on your roof top in a short period of time plus add in the fact that pigeons are flocking birds and so other pigeons flying by will stop and move in to be close to a flock of other like minded pigeons and then it gets really bad from there.

Call us today we can solve your pigeon problems by cleaning under the units and closing off the access so that pigeons can't nest under the units and then add live trapping to the clean and close service and get rid of most all of the flying rats on your roof top.

Below are some samples of larger HVAC units

Stand Off brackets

 They are mounted on the corners of the unit and support a perimeter cable approximately 2 feet above and 2 feet out from the outside edge of the unit. Two additional cables are installed diagonally from the end of each standoff support arm (corner to corner) to support the standoff arms and to provide support to the net in the middle of the unit, this insures that the net will not sag down onto the equipment

On smaller units a cable tension system holds the standoff brackets securely in place allowing installation without penetration of the HVAC unit with screws. Adding two sheet metal screws per corner adds strength. Larger units with spans greater than 10 feet should have sheet metal screws used to fasten the standoff to the unit.

   The protective net is net ringed to the supporting perimeter cable and down the corner seams. The weighted line is also net ringed securely to the bottom of the net to insure a clean and tight installation.

   A zipper can be installed in the net to allow access to the interior of the protection system. In the second example described here a 6' zipper is installed that allows easy access for maintenance.

Swamp Coolers   - coming soon....

B4 / after pictures

Copyright © 2004 Arizona Wings-N-Stings   All rights reserved.    Revised: 10/09/10.